Equipment

Jardis single splicer, built in 2000 (est)

• Very good condition
• 38" wide, 45" diameter, 30,000/hr
• Microprocessor controlled
• Low-riding festoon
• Motorized sidelay
• Complete hoist
• Two coreshafts
• Dual-dancer, dual-unwind independent tension control

Single Enkel splicer, model 084045SE. 1998

• Feeds right to left
• 45" max roll diameter
• 40" max roll width
• Rated speed 25,000/hr, easily upgradable to 30,000/hr
• 2500# hoist, rails & 2 coreshafts
• Relay logic
• Motorized sidelay
• Low riding festoon
• Wired for 240vac but can be converted to 480vac

Enkel Model 103845

These splicers were built in 1988 and have a speed rating of 30,000 copies per hour or about 1000 feet per minute. Maximum roll width is 38 inches and maximum roll diameter is 45 inches. These could be converted to hold 50 inch diameter rolls fairly easily. The splicers come with:

• Relay logic controls
• A shared 2500 pound hoist
• 4 Tidland coreshafts (steel)
• Motorized sidelay
• 480 VAC incoming power
• Two webover rollers.

Enkel Model 083845

These splicers were built in 1985 and have a speed rating of 25,000 copies per hour or about 800 feet per minute. Maximum roll width is 38 inches and maximum roll diameter is 45 inches. These could be converted to hold 50 inch diameter rolls fairly easily. The splicers come with:

• Relay logic controls
• A shared 2200 pound hoist
• 4 Tidland coreshafts (steel)
• Motorized sidelay
• 480 VAC incoming power
• Two webover rollers.

Four Jardis splicers arranged as two tandems

• 38" wide, 45" diameter, 30,000/hr
• Microprocessor controlled
• Low-riding festoon
• Motorized sidelay
• Two complete hoist assemblies
• Two coreshafts per splicer

Ebway, two-web angle bar

Coreshafts

Used & rebuilt Enkel coreshafts. Good drive ends no leaks. $400-$600 each.